Airhead Reference › The book › Bottom End › Crank end float
Bottom End · Crankshaft

Crank end float

▲ Safety-critical — over-torque-intolerant. Do not exceed the figure.
Metric
0.08–0.15 mm
Inch
.0032–.0059"
Applies · All
Set by coloured thrust washers. Grabby clutch, hard shifting, idle change w/ clutch pull when hot = re-shim. Differs oily vs dry.

This is the book's general row. In the book, pick your model and year and this figure resolves to your machine, with the one-page torque sheet, the job pages and the printable booklet.

Open in the book
Report an error in this figure

If this figure disagrees with your manual, say which manual and which page. Every report is checked against the source before anything in the book changes.

Also in Crankshaft