Airhead Reference › The book › Splines & Driveline Lubrication › U-joint to output flange (4)
Splines & Driveline Lubrication · Torques you meet on the way in

U-joint to output flange (4)

▲ Safety-critical — over-torque-intolerant. Do not exceed the figure.
ft-lb
26 ±2
Nm
35 ±3
Prep
One drop blue Loctite · clean dry · NO washers
Applies · All — current spec
Max 29 ft-lb, criss-cross. Use only the short bolts 26-11-1-242-297 (from 1983); the old long bolts 26-11-1-230-414 with split lockwashers are superseded, and long bolts without washers can damage the seal behind the flange. Never reuse the lockwashers.

This is the book's general row. In the book, pick your model and year and this figure resolves to your machine, with the one-page torque sheet, the job pages and the printable booklet.

Open in the book
Report an error in this figure

If this figure disagrees with your manual, say which manual and which page. Every report is checked against the source before anything in the book changes.

Also in Torques you meet on the way in