Airhead Reference › The book › Torque Specifications › Paralever pivot pins
Torque Specifications · 33 · Rear Drive & Shocks

Paralever pivot pins

▲ Safety-critical — over-torque-intolerant. Do not exceed the figure.
ft-lb
11 → back off → 5.5
Nm
15 → back off → 7.5
Prep
Clean threads
Applies · Paralever
Set 15 N·m, back off, re-set 7.5 N·m. Locknuts 75–80 ft-lb. LH pivot stub 80 ft-lb. RH pivot shaft 3.5 ft-lb with lock nut 77 — the low figure is not a typo.

This is the book's general row. In the book, pick your model and year and this figure resolves to your machine, with the one-page torque sheet, the job pages and the printable booklet.

Open in the book
Report an error in this figure

If this figure disagrees with your manual, say which manual and which page. Every report is checked against the source before anything in the book changes.

Also in 33 · Rear Drive & Shocks